It wasn’t until recently that I heard people were using watermelons as beverage holders. Since yesterday was National Watermelon Day, it seemed the perfect excuse to try my hand at creating one!
I have made many a watermelon basket in my day! Even as a teenager, I loved carving out a watermelon to fill with a fruit salad for a party or get together. The older I got, the more ornate my baskets would become!
Using a watermelon to create a vessel for a beverage seemed pretty similar to making a watermelon basket. It is an easy concept: Hollow out a watermelon; cut a hole and add a spigot; fill it with a beverage!
To try your hand at making one, first examine your watermelon and decide which way you want it to stand. When you have the top and bottom picked out, make a very thin slice in the ‘bottom’ so it will stand up nice and straight without rolling over. Be careful not to cut too much off, or you could spring a leak in the bottom!
The spigot is easy to install. Cut a small hole the diameter of the spigot. Then add the spigot – a washer will hug each side of the watermelon; the nut will cap off the inside.
Then, cut off a slice from the top. Use a large, strong metal spoon to scoop out all the good watermelon and reserve it in a big bowl. (I also saved the juice from the watermelon by pouring it into a pitcher.)
Cut a hole for the spigot and position it near the bottom of the watermelon. (Remember that the section of liquid below the level of the spigot will not flow out.)
Now you are ready to fill your beverage container with whatever beverage hits your fancy! I decided to make something of a jazzed up watermelon water. I had enough melon to make the water and still had leftovers for snacking!
Watermelon Water
6 cups of watermelon, pulverized in a blender (you can count the liquid from the watermelon as part of the 6 cups.)
Juice of one lime (or to taste)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Mix ingredients. Strain. Chill. Garnish with basil or mint leaves from garden. ;)
You may decide to fill your watermelon with a punch or some type of alcoholic drink (for those over 21) for your next party. My only advice is to be sure to strain any fruit drinks prior to putting them into the watermelon container. This ensures no pulp will clog up the spigot.
I know there are spigots marketed now as “watermelon spigots,” but you really don’t need anything special for a watermelon. My spigot cost $4.99. The only adjustment that may be needed is if the spigot is not long enough for the width of your fruit. I needed to shave mine down a little to be sure the washer fit on the back. I probably could have found a longer spigot, but it was easier just to make the width of the watermelon a little thinner in the spot where the spigot attached.
Now that I know it works, I can try some variations! Just like my watermelon baskets, I can see my beverage holders will also get ‘fancier’ over time! How about a row of fish carved around the top rim? Such possibilities! And, there are so many cute ways to set up a beverage station! Give it a try!
Thanks so much for stopping by! Remember to take pleasure in simple things, Jackie
Sharing with Shabby Nest, Craftberry Bush, House of Hipsters, Sand & Sisal and Coastal Charm.